I am looking at high speed wireless through a provider, but they don't have public IP addresses unless you pay an additional $10 per month.
I have used NO-IP and DynDns for years, but ...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Just need cost of postage, and I'll send it to you. Moved to DSL and no longer need cable modem. Used it with Charter Cable in St. Louis.
tenholde
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I'm running an XP PC with HS2 controlling a variety of functions via a CM-11 interface and X-10 modules. Because I'm frequently away from home for extended periods I neea a backup for...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I just installed one of these puppies to run an instance of ML Client with a serial Elo touchscreen attached ... and it is definitely exceeding my expectations, especially at the price y...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
i have a ups monitoring script that set a virtual device value to the value of the ups load (a number for 0 to 100%)
i have noticed that each time the setdevicevalue is called a devi...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I'd like to build a new HS server and I'm looking for sizing recommendations. I searched but couldn't find where this has been discussed before. I'm sure it has - I just couldn't find it...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I just installed the RCS TZ43 and I have an April Air Humidifire that has a TEMP prob(Outside) connected to it (2 Wire). Can I split the two wires from the single Temp Probe and run to t...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I don't see any specific installation instructions for the Wayne Dalton WDTC-20 thermostat (same as Intermatic CA8900).
So I started a Wiki page on it: http://www.homeseer.com/wiki/ind...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Guys
I have a device that can be spoken to via a serial port or IP.
I have the device protocol working with the serial port, but would like to move to IP based comms.
G...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Just saw this at NewEgg. Don't know if it is a good deal or not, just thought I'd throw it out there
http://www.newegg.com/Product/Produc...L0D-_-81102002 [http://www.newegg.com/Produ...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
1 Radio Shack 61-2576R RF Receiver Plug in Power
1 RCA Home control base Module HC50RX
1 X-10 AM 466 3 pin appliance module
1 X-10 LM 465 Lamp module
1 IBM Home Director Lamp Module
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I have the client installed on an old Win98SE laptop that I use to power a touchscreen. When the client starts it hangs on a screen with a dialog that states "Copying Files" and never g...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I am trying to raise money to replace my whole house music system. I realized this weekend that I had a LOT of Home Automation stuff lying around that I was no longer using, and most of...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Post any issue or request in this thread.
The changes list is available here [http://www.cyvinec.com/message_server/changes.html]>.
Regards,
Christian
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Looking to buy new/used AB8SS. Please PM me if you are selling.
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Can anybody recomend an online shop for Z-wave sensors, dimmers etc. with EU frequencies?
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Hai,
I have the following problem:
I have just bought me the HS2 licence and the Mediaplayer plugin and installed it all, the mediaplayer plugin button is shown in the HS screen and wo...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I can't get this to work with the new beta (it's the only beta I've tried and that's just to see if I can get HStouch to work).
DooNetwork does not seem to save devices and does not wake...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
For some reason the events I am trying to trigger with Doomotion aren't working. I have the garage light setup to turn on when there is motion andin Doomotion the sensor is setup as a m...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Guys
I am running this from an event....
&hs.RunEx "script.txt", "SendCommand", "G20"
Now, I would like to add after G20 the devicestrings of two devices.
How...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Just in the last week I have noticed that periodically mcsTemperature will quit for no reason. There is no log event. There is really no indication at all until I try to look at the m...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I have been using this for a while with no problems. I want to increase the number of days it keeps from 7 to 30 (I am making a lot of changes to my scripts and wanted to make sure I am...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I saw a cool video online the other day about how some guys were using the Nintendo Wii remote for some cool applications. That got me to thinking that it would make a nifty little hand-...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
anyone know what could cause this?
filled my logs bigtime last night and still going on...
10/26/2008 8:42:19 AM ZWave Thermostats Error sending ZWave Command, aborting: 1
...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
It’s time to clean up and clear out everything. Since we all like to negotiate and get the best deal, make me an offer if you have any interest. Shipping charges will be coming from 60...
[Tags: No tags defined yet] - Be the first to Tag this threadAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Browse sub-categories 
