I am looking to get a little more out of my V. The car obviously has potential but feels a little choked up. I am looking to put down around +400whp and would like to do so as quietly as possible, which is an oxymoron in itself.
I was wondering if any...
[Tags: stock-exhuast, header] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I'm pulling my header and exhaust pipe and the bolt that holds the mount in the middle (under the driver seat) is old and seized.. I'm thinking about cutting it off with my roto-zip.. are there any safety issues here?
Also, i have a new header gas...
[Tags: header] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I finally finished my wife's 60, I put on a set of sor headers, felpro gasket, had the intake belt sanded, rebuilt my power steering pump, new hoses, valve cover gasket replaced new pulgs, cap, rotor, wires. smog pump eliminator 2 1/2 inch exaust all ...
[Tags: desmog, header, leak] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Pantec 2500 ultra with 12 pin jtag header
If you going to build jtag cable make sure that you use pins 109 to 113. and connected correctly. to jtag cable. cable can not be longer than 12 in. data sheets ...[see attachments]
c&p,thanks goes to t...
[Tags: pantec2500, ultra, jtag, header] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
This might sound stupid, but I know after you install headers you have to retorque them, but how do you do that when the black plate between the carb and intake is inplace??????
...
[Tags: sor, header, torque] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Hey,
I have re-chromed headers from man-a-fre(Equal length, ceramic coated)
http://www.man-a-fre.com/parts_accessories/HeadersTunedCeramicCoatedFand2FEngines.htm
I only used them for the initial timing of my engine. They were re-chromed for free by ...
[Tags: pto, header, winch] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
I'm trying to figure out the best header and intake manifold combination for my 1985 60 with a completely stock 2F. I have the dreaded intake manifold crack and decided if I could get a little more power and mileage out of my 2F while I have the whol...
[Tags: header, exhaust manifold, intake manifold] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
So, why change your welcome headers to an image?
The same exact text is being read on every single page by the spiders who see it. Because of it's prominent placement on forums, they are apt to use it to describe each of your page.
We started seeing b...
[Tags: vbulletin, optimize, header] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Search matches - Showing results 1 - 11 of 11
