Im unsure as to what spark plugs would be recommended for my setup. I have a 91 civic with a b18a1 swap. I have an MSD Pro Billet Distributor & all the recommended parts. Plus I have an MSD SCI-L Ignition Box aswell. But what type of plug would be bes...
[Tags: msd, plugs, spark] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
ok so i had my swap in for a couple monthes... it ran a 13.6... its a fully built b16a ina 90 da... but ya heres my problem i was redoing my exuast a couple days ago and i was at a buddys house well i did new headers and i cut and rewelded the bracket on ...
[Tags: b16, coolant, crack, head, jdm, leak, leaking, plugs, spark] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Well I was on my way to go home, which about 500 mile trip, and all the sudden she shut down in the middle the street. After trying to crank it over, found that its not like the belt came off. Still getting fuel because its holding fuel pressure per my g...
[Tags: timing, spark, igniter, distributor, coil] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
Got a '90 CRX. Replaced the distributor, coil, igniter, cap, rotor, wires and the wiring harness going from one of the plugs to the igniter and coil. These were replaced due to a start-run for a second- die -condition. Now it fires up but wont go past 35...
[Tags: distributor, misfire, spark] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
hey guys, i just got finished dropping a jdm b16a into my usdm 91 integra. everything is ired up and everything is hooked up mechanically. heres my problem...my engine will turn over but there is no spark. i dont think it is the plugs because i checked fo...
[Tags: plugs, spark, start] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine
hey guys, i just got finished dropping a jdm b16a into my usdm 91 integra. everything is ired up and everything is hooked up mechanically. heres my problem...my engine will turn over but there is no spark. i dont think it is the plugs because i checked...
[Tags: plugs, spark, start] - Add more TagsAdd TagsCancel
*Note: Tags must be comma (,) seperated. For example: boardtracker, forum search, search engine